What Are The Precautions For Using Innova Horizontal Sterilizer?
The #Innova horizontal #sterilizer enjoys extensive usage with a proven track record. Its key attributes include a wide sterilization spectrum, potent sterilization effect, reliable outcomes, swift action, and absence of residual toxicity. This sterilizer is well-suited for disinfecting a range of heat-resistant items, including liquids.
Some tips when using horizontal sterilizers：
?????1. Different types of items should not be sterilized at the same time. Such as dressings and solutions, rubber and instruments, etc. In order not to lose sight of the other and fail to achieve good results.
?????2. In case of power failure or accident, cut off the power immediately, and open the condensation control valve and drain valve at the same time, so that the steam in the interlayer and inner layer can be discharged in time, and the pressure gauge returns to "0". And accidents should be marked on the sterilizer and dealt with in time.
?????3. Electric heating requires a three-phase power balance, otherwise, it is easy to burn out the fuse or electric heating tube. At the same time, always observe the water level. If the water level is low, add water in time. Regularly remove the scale on the conductive posts.
?????4. The pressure gauge and safety valve should be checked regularly. If any fault or damage is found, it should be repaired or replaced in time. The handle of the safety valve should be lifted once or twice a week to keep it flexible. 5. The electrical connector should be checked frequently to prevent loosening. The equipment should be properly grounded to ensure safety.
?????6. The sterilizer should be kept clean and dry, especially when it is not in use temporarily, it should be wiped clean to avoid corrosion, and the rotating parts should be lubricated in time.
?????7. To avoid corrosion of stainless steel by chloride ions, pay attention to the chloride ion content in the water used shall not exceed 25ppm.
8.?The sterilizer should be operated under good conditions and maintained regularly to ensure normal operation.
?
领英推荐
Precautions for use of INNOVA horizontal sterilizer:
?
???????1. Do not open the sterilizer cover before the pressure reaches zero MPa.
???????2. When the pressure gauge is abnormal, stop using the medium-sized steam sterilizer of Zhonghai.
???????3. When opening the lid of the sterilizing pot, pay special attention to the steam in the sterilizing chamber to prevent burns.
???????4. When placing the sterilized items, be careful not to touch the temperature probe of the inner tank.
???????5. When the water level in the exhaust bottle is higher than the high mark, pour the water to the low mark, and then sterilize.
???????6. When the water level in the pot is lower than the limit mark of the crossbar in the center of the chassis, add an appropriate amount of distilled water near the limit mark of the crossbar.
7. In order to ensure the smooth flow of the pipeline and not block the pipeline system, it is customary to?change the water frequently; when the high-pressure steam sterilization equipment in the sea is not used for a long time, the water in the sterilizer should be drained.
https://www.innovabiomed.com/product/autoclave-sterilizer.html