Tyco Dry Installation of Radiant Floor Heating

------Tyco dry floor heating system

---Variety:Underfloor heating panel with aluminum foil

Underfloor heating panel with aluminum sheet

Mushroom type heating panel

---Installation

In order to solve the problem that the traditional wet floor heating installation method is difficult to construct, the construction period is long, late maintenance costs a lot, then the dry installation method is generated. The dry installation no longer uses the concrete layer to fix the plumbing pipe. Instead, it only need to put the pipe into the groove, which is very convenient. The floor is directly laid on the groove of the panel, the hot water is transferred to the floor through the aluminum sheet and foil to achieve rapid floor heating. It is equivalent to the radiator installed on the ground, especially suitable for installation in high humidity areas.

--- Market

Dry floor heating installations are popular in the Europe, and in the same configuration, the price is slightly higher than wet floor heating by about 5-10%, but it allows the owner to save 4-5 cm of floor height and long-term use. Floor heating Panel is installed under the tiles, marble and wooden floor. Because the heating panel has high compressive strength, it can save the backfill layer and reduce the height. The panel is usually installed in the bathroom, kitchen room, dining room and other places. It can also be installed in the room. Dry floor heating has matured through a large number of installation practices.

---Advantages

Compared to the wet floor heating installation process, Dry heating panel has the following advantages:

1. The floor heating system can be repaired conveniently.

2. No need for pipe clamps, cable ties and steel mesh, greatly simplifying the construction process, because the cement maintenance period is not required, the construction progress is shortened from one week to two days;

3. Both heating panels and pipes are plastic, the thermal expansion and contraction coefficients are similar, which solves the problem that the pipe is cracked and the cement layer is cracked due to the thermal expandsion;

4. Since the cement layer is omitted, the keel layer and the floor heating layer are in the same flat, the thickness of the entire floor layer is only 4.5-5 cm (including 2 cm of insulation heating), which low the total height. In contrast, if the wet installation, when laying the keel, the cement layer is generally 10 cm, the keel is 3 cm above, which requires a total height of about 13 cm;

5. The dry installation can be easily applied to the keel and keel-free floor, the wooden floor decorative layer can be directly laid on the panel, and it is suitable for laying the heat regenerator;

6. It can be used for health care by selecting Panel with health functions of far infrared and magnetic therapy. This panel adds a far-infrared warm-up launching and magnetic field particles capable of generating far-infrared rays.

7. The panel is a light material, without the need for cement and screed, saving material, transportation costs and labor costs, and reducing floor load.

------ More details please contact:

Cathy Yu---TYCO underfloor heating system

Whatapp & Wechat:+86-13777358724

Email:[email protected]; [email protected]