Three dedicated Sessions on Grid Forming
Featured Wind and Solar Topic

Three dedicated Sessions on Grid Forming

During the last RE Grid Integration Weeks - with several well-filled sessions and many insightful discussions - Grid Forming was one of the most sought after topics.

We intend to continue this year where we left off last year. That is why Grid Forming will again be prominently featured Solar & Wind Integration Workshop that takes place from 12 – 14 Oct in The Hague & virtually.

Have a look at some of the exciting presentations that await your during the event:

  • ?Grid Forming and Grid Following Comparison for an Offshore Wind Farm Connected Via A HVAC Cable - R. Alves (University of Strathclyde, United Kingdom)
  • Grid Forming Operation of Type 3 Wind Turbines - V. Gevorgian (NREL, USA)
  • ?Design Considerations and Test Results of a Grid-Forming DFIG WTG - D. Howard (General Electric, USA)
  • The Opportunity of Grid-Forming Converters in the Wide Area Control of Power Systems - R.?Musca (University of Palermo, Italy)
  • Towards Standardized Testing Procedures for Inertia Provision of Grid Forming - N. Sch?fer (Fraunhofer IEE, Germany)
  • Comparison of Current-Limitation Approaches for Grid-Forming Converters Enabling Fault-Right-Through Operation in Converter-Driven Power Grids - J.?Struwe (University of Applied Sciences Duesseldorf, Germany)
  • On the Low Risk of SSR in Type III Wind Turbines Operating in Grid-Forming Mode - S. Shah (NREL – National Renewable Energy Laboratory, USA)
  • Controller Tuning and Performance Selection for a Grid Forming Battery Energy Storage System Project - J.?Mesbah (DIgSILENT Pacific, Australia)
  • Performance Improvement of DFIG-based WECS with Non-Linear Load Penetration Using Additional DSTATCOM - H. Kumar (Indian Institute of Technology Jodhpur, India)
  • Overcurrent Protection for Grid-Forming Converter under Unbalanced Faults - N.?Wiese (University of Kassel, Germany | Fraunhofer IEE, Germany)
  • Evaluating Flicker Damping Capabilities of Wind Turbine Inverters with Grid Following and Grid Forming Controls Applying the Proposed Cases in IEC 61400-21-4 - L.?Rezai, (HTW Berlin, Germany)

?

Find more information on all presentations dedicated to Grid Forming as well as the wide range of other featured topics in the Wind & Solar Workshop agenda.

Balaji Suguna

RPEQ, CPEng, MIEAust, NER, CEng MIET, Senior Electrical Engineer (Power System Studies/Planning) at PSC Australia

2 年

Is there any opportunity to attend these sessions remotely using some video conferencing platforms?

回复

要查看或添加评论,请登录

Thomas Ackermann的更多文章

社区洞察

其他会员也浏览了