The Rosario Inker Service Toe-in Table

The toe-in table is a new design to set the toe-in of the plate cylinder shaft at +0.01mm. By checking your own inker-stands you'll find that they often don't have the right accuracy to set a proper toe-in of the plate cylinder shaft. Also most can plants can`t check the pockets of their inker-stand as there is often no blueing bar available. This tool is optional.

The top-plate of the toe-in table is completely grinded so it meets the necessary accuracy. After the height of the left and right pocket is checked by a blueing bar and they are both the same height (=0.00mm height difference), the toe-in of the plate cylinder shaft can be set at exactly 0.01mm. In order to keep this accuracy the toe-in table is mounted on the floor by 16 bolts. It is advised to use the inker toe-in table only for checking-setting the toe-in of the plate cylinder shaft and. No assembly should be allowed on this table.          

The toe-in table comes with a magnetic base holder and an indicator.

A blueing bar is a fixture that is used to check the alignment of a 6- or 8- color kit or a toe-in table alignment. It is very important to check the inker-stand pockets and the pockets of the 6- or 8-color frame. If the pockets of the inker-stand pockets don`t have the same height, it is impossible for the plate cylinder shaft to have the right toe-in. This is the same with the pockets of the 6- or 8-color frame. If the height of those pockets doesn't match with the blanket segment, the pressure between the blanket segment and plate cylinder shaft won't be within the specs. 

If you are interested and would like to receive more information, contact us at LinkedIn or at our email address:[email protected].