Precautions of Pyrolysis Project

Waste tyre?pyrolysis plant?is the key part of oil refinery project. If a failure occurs during the operation, it will affect the recycling schedule and economic benefits of the project. So maintenance is more important than repair, and prevention is more important than repair. Therefore, it is significant to understand the precautions and maintenance methods of the pyrolysis machine during operation.

Huayin?has rich experience in equipment installation and training for workers on standardized operation during these years of customers' service. We conclude that regular inspection and maintenance of machine to ensure smooth running and also extend the life of the plant.

Regular inspection before operation of tyre?pyrolysis plant

1. Be sure to check the condition of the motor before each operation of the machine. If the motor is overloaded or suddenly started or reversed, it will also cause damage;

2. The safety device is very important of safe operation, and it is necessary to check whether the pressure thermometer and safety valve can work normally;

3. Checking whether the seal is good, whether the screws are fastened before ignition, and strengthen the equipment at the same time.

Things you should know in?pyrolysis plant?operation

1. The operator should know the performance of the machine, mechanical structure and operation procedures in case the equipment was damaged due to improper operation.

2. Operators should stick to their posts, monitor the operation status of the equipment carefully, and shut down for inspection and repair if abnormal situation are found.

3. If the tyres in the reactor are not pyrolyzed completely, it is forbidden to open the slag discharging port and the feeding port.

4. Be sure to pay attention to the explosion-proof aluminum plate. If the aluminum plate is damaged or leaking during the pyrolysis process, the valve outside the explosion-proof device should be closed immediately, and the explosion-proof aluminum plate should be replaced in the end.

Maintenance methods of tyre?pyrolysis plant?after operation

1. Regularly overhaul and maintain equipment, dredge oil and gas pipes and condenser pipes;

2. Regularly check whether the amount of oil in the lubrication pump oil tank and the engine base oil tank is sufficient to ensure the reliability of the lubrication system and lubricate the moving parts;

3. Regularly check whether the tugs, bearings, and gears are running normally, and add lubricating oil for lubrication;

4. Regularly clean the oil filter to see if there is carbon black agglomeration and blockage. If there is blockage, it should be cleaned or replaced immediately.

It will be better if equipment management file can be established to archive information about equipment failure records, test records, repair parts replacement records, spare parts consumption, etc. This would help you to grasp the equipment status in real time and avoid affecting the progress of the factory.

Huayin?has 28 years experience in waste tyres and plastics recycling project, we have strict standards for the selection of equipment materials and quality control. If you have any interest, feel free to contact us!