Our Choke Info .

Our Choke Info . https://mullerchokes.com/pages/choke-selection-and-information

Featherlite and SS Constrictions: U0 has most open pattern, U4 has tightest

ü0 – cylinder/ Skeet* (in your face, out to 28 yds on edge)

ü1 – Skeet/Improved Cylinder* (out to 35 yds on edge)

ü2 – Light Modified (out to 45 yds on edge)

ü3 – Mod/Improved Mod* (out to 60 yds on edge)

ü4 – Full/Extra Full (beyond 60 yds on edge)

The labeling of constrictions is a little bit different than other chokes. For example, our U1 will give a Skeet diameter outer fringe pattern. But, it will also break targets as far, accurate, and hard as an improved Cylinder due to the even pellet distribution.

How much constriction are the U0, U1, U2, U3, U4 in Thousandths of an inch?

As for the constriction measurements, it is different for every gun due to Jim making gun specific pattern geometry for each gun.

Depending on bore diameter of your gun it will vary a little, but as an average they are approx as follows:

U0 = .002",U1 = .005", U2 = .012", U3 = .022", U4 = .035

What is the difference between Featherlite or Stainless Steel?

Featherlite:

Our Featherlite choke is made out of aluminum and is half the weight of Titanium, 1/3 the weight of steel.

Ceramic Teflon infusion results in the hardest, cleanest choke on the market

Specifically for clay targets

Can only handle certain shot size and material:

Only use lead

Only use size 7.5 or smaller gauge (7.5, 8, 9, etc… is okay)

Nothing “bigger” than 7.5 (NO 7, 6, 3, 2, etc…)

Stainless Steel:

A bit heavier than the featherlite

Can be used for both clay targets and hunting

Many use target guns for hunting so we wanted to have an ultimate choke choice for hunting loads and non toxic shot (anything other than lead)

Made out of Stainless Steel coated with “cerakote” rust preventative military grade coating.

Can handle any size shot or material (no restriction!)

Can use lead, steel, any heavy shot

Can use any size: 2, 3, 4, 6, 7, 8….

What Choke Should I Buy?

Skeet- ü0 (2 U0 for over/under guns)

Trap:

American Trap, Doubles - ü2/ü3

ü2 – for the 16 and 20 yard line

ü3 – for the Handicap (20- 27 yard line)

Sporting Clays - typically a ü1/ü2 or ü2/ü2 combo

ü0/ü1 – for close targets inside 35 yds.

ü1/ü2 – for “normal courses” out to 40 yds.

ü2/ü2 – for “challenging courses” out to 45 yds.

ü2/ü3 – for “difficult courses” out to 65 yds.

ü3/ü4 for “Pro courses” past 60 yds.

3 Gun: Specifically for 3 Gun Competitions

Made of steel so they have no restriction on shot size or material- can be used with slugs.

Hoser- Inside 25 yards, similar to our U0 (Cylinder/Skeet)

Far- for precision targets, has far and tight pattern, similar to our U3 (Modified)

Hunting:

Decoy – inside 35 yds (good for hunting over a dog)

.007

U1/U2

Passing –35-50 yds

.025

U3

UFO - beyond 60 yards

.040

Turkey - tight pattern (same as UFO)

Can be used for turkey hunting

Also for card shoots and turkey shoots (where the tightest pattern at a close distance is needed)

Ammo/Other Info

In regards to Feet Per Second: 1300 FPS or less for the best pattern, 1400 FPS starts to change pattern, 1600 FPS will blow pattern

The roundest, most consistent ammos out there are as follows: B&P, Gamebore, and Remington.

For hunting:

Federal, Fiocchi Golden Pheasant

For hunting over a dog, use our Decoy choke

Jim prefers shot size #6

Back Boring: When a gunsmith or machinist bores or hones out the barrel I.D. (inside diameter) to make it larger in size. This causes a major choke tube issue! You can no longer shoot a “standard choke” that is made for that model shotgun. It now would require custom chokes forever. (Jim does not recommend)

We do not make chokes for any aftermarket back bored barrels

Cleaning:

Use Qmaxx Black Diamond or Rem oil as a cleaner or lubricator

If you are one who leaves your chokes in the barrel for extended periods of time he recommends good old bearing grease.

Bore snakes are O.K. to use

Do NOT use Anti-Seize or Simple Green

**Our warranty is voided if anything other than recommended products

Lapping Compound: Just apply a small amount to the thread area and using the wrench, spin choke in and out until it fits all the way in perfectly. Then oil choke and wipe off lapping compound.

Use if your choke seems tight going into your barrel

Loosening chokes

Use our choke wrench

Put grease on the threads

Returns/Exchanges:

We have a 60 day money back guarantee. If you would like to return the chokes, please include a note specifying this in the package.

If you need to exchange a choke for a make of choke or constriction, please include a note specifying this exchange as well.

Please send packages to our office address:

2382 Sadler Road

Fernandina Beach, FL 32024

Shipment Notes:

Muller Chokes is NOT RESPONSIBLE for lost, held, stolen, or damaged packages. Ownership of packages is transferred to you, the buyer, as soon as your package leaves Muller Chokes and is in the possession of your chosen shipping carrier. We are not responsible for delivery errors via carrier, or incorrect shipping info. Shipping is a service you purchase along with your order from us, so any shipping issues must be handled with your chosen carrier. We recommend you ADD INSURANCE to your order if you want your items protected and covered by the CARRIER.

International Orders:

?We currently ship everywhere except to Russia internationally. We recommend selecting UPS as your carrier as they are guaranteed and/or add insurance to your package. We are not responsible for any lost packages. Our shipping costs do not include any other import taxes or charges that you may be charged with