Meet the Metrix Proximity System Accessories which will make (your) life on site much easier!

Stop wasting precious time on site! Metrix offers a full line of accessories for your proximity systems which will definitely make life easier during service and installation.

Meet the great family members of our Proximity Systems Accessory Product Family:

MX8020 Cable Trimming and Connector Kit

The Metrix MX8020-001 Cable Trimming and Connector Kit provides an easy way to reduce the length of an extension cable and maintain the electrical integrity of the MX8030/8031 or MX2030/2031 Proximity Probe System.

5497PM Probe Mounting System

The Probe Mounting System works with reverse mount 8mm proximity probes. The system mounts on the machine surface for easy installation.

5498JB Conduit Body (Junction Box) with Low Pressure Feed Through

5498JB Conduit Body provides a convenient junction box for internally mounted proximity probe connections. The four 3/4” NPT conduit penetrations make fitting up conduit easy.

5499 Heavy Duty Reverse Probe Mount Housing

Required accessory for reverse mount probes. Provides physical protection to 1000 PSIG (6.89 MPa).

7646 Probe Mounting Bracket

Available for all standard probe sizes.

1/2” NPT Threaded Hole Probe Holder

Available for all standard probe sizes.

3/4” NPT Threaded Hole Probe Holder

Available for all standard probe sizes.

5494LP Low Pressure Feed Through

Low Pressure cable seals prevent oil wicking with proximity probe sensors in rotating equipment. The seals include a grommet that provides a tight seal and also allows adjustment of the cable position.

5494 Feed Through Extension Cables

Extension cables with High Pressure Cable Seal to 150 PSI used for 10000 and MX Probe Series. Available as single or dual feed through.

Static Calibrator

The static calibrator tool allows users to change their probe target material to match their specific probe system. Available for millimeters or micrometers.

MX2040 Dynamic Signal Checker

The MX2040 dynamically tests the vibration monitoring system loop by the simulation of rotor vibration.

9060 Shaft Calibrator Dial Micrometer

The Metrix Shaft Calibrator is used to determine the actual proximity probe system output in mV/mil or mV/μm of a machine shaft or piston rod.

9060 Shaft Calibrator Touch Select

The 9060-SCTS (Shaft Calibrator Touch Select) is used for testing 5mm, 8mm or 11mm proximity probe systems with a minimum probe body length of 63mm (2.5”) when used as a static calibrator and a minimum probe body length of 100mm (4.0”) when used with the shaft mounting adapter.  It is also very useful for testing reverse mount probes with the probe holder still attached.

7876, 8172 and 8173 Weatherproof Housing

NEMA 4 / IP 65 rated enclosures for 2, 4 or 8 units.

7595 and 8156 Explosion Proof Housings

Explosion-proof housing helps protect your proximity drivers, transmitters and signal conditioners in harsh environments. NEC & CSA rated for Class I, (C,D) & Class II (E, F & G), Div.1 areas.

9041-XXXX Signal Cable

Bulk cable for wiring probe drivers, monitors or signal conditioners.