Liquid Glass Solar Panel Coating - Can more output be generated?

Photovoltaic modules produce their best yield under optimal conditions. With the CCM? Liquid Glass coating for solar panels, the amount of light transmittance to the PV cells increases. Cleaning becomes much easier, and the cleaning cycle requirement is significantly extended. These factors lead to an increased yield of your system.

THE PROBLEM WITH SOILING

Soiling is not only caused by leaves, tree needles or pollen, but also by dirt particles in the air. Bird droppings can be particularly unpleasant and can even cause etching on the module surface. In addition, the edges of the solar panels tend to attract heavier soiling. This soiling ranges from salt and sand build-up to moss or lichen formation; depending on the location of the panel.

In principle, soiling on the photovoltaic modules acts like shading and this reduces the yield of the photovoltaic system. Depending on the degree of soiling, this reduction in yield can amount to between 10 and 20 percent. This makes it almost impossible to generate a decent return. In addition, soiling at the edges of the PV system leads to an increased need for repair and maintenance.

Our easy to apply and highly durable PV coating offers instant benefits.

PROPERTIES

• Advanced SiO2 technology which creates an invisible protective layer, approx. 100 nm (nanometres) "thick”. Approximately 500 times thinner than a human hair, therefore no negative impact on light transfer.
• Protects the surface against abrasion and degradation
• Heat and frost resistant
• Resistant to sea water, and acid / alkaline 1.5 to 12.5 ph
• Water and dirt repellent
• Easy and quick application
• Can be applied at +10° to +30°C
• UV-stable
• "Easy-to-clean" effect (surfaces become easy to clean = time and cost saving. Heavy surface soiling is often washed off by rain)
• Coverage: Apprx. 150m2 with one litre

Reduces the negative ecological (CO2) footprint when cleaning:

• Less water is needed
• Zero Chemical cleaning

Up to 10% more output can be generated in wet weather conditions.

ADDITIONAL BENEFITS ASSOCIATED WITH THE COATING SOLAR PANELS WITH CCM? LIQUID GLASS SOLAR PANEL PROTECTION.

• The negative impact of rain, snow, ice, and sun are significantly reduced
• Soiling deposits such as bird dropings, pollen, environmental pollution etc. become easy to remove or wash away during heavy rain = increased light / energy transfer
• Pollution is normally "baked in" by the sun = reduction in the service life of the panels. Coated solar panels prevent the baking in of soiling agents, therefore significantly extending the working life of the unit

DID YOU KNOW?

The CCM Windscreen Coating Technology on E-Vehicles

When driving in winter conditions most E vehicle drivers suffer from Range Anxiety. Do I shut down my car heater? Do I run on side lights? Even using the car radio becomes an issue. It is all going to drain the batteries but it gets worse.

It is winter and you have to drive from London to Manchester, Berlin to Bremen or New York to Washington. The windscreen wipers will be drawing 400 watts for the next 5 hours and this means you have been tipped beyond the battery range because of needing to constantly use your windscreen wipers.

The solution is simple.

Enjoy better vision, and reduce the drain on batteries by using the CCM TUV tested windscreen coating.

Further information about the solar panel coating: