Linear motion vibrating screen

Linear motion vibrating sieve can remove impurities and classify dry powder or granular materials. Different types of linear motion vibrating sieve have different sizes, and the corresponding processing capacity is also different. This article will introduce the technical parameters of linear motion vibrating sieve.

Models of linear motion vibrating sieve

The linear motion vibrating sieve has a screening mesh of 400 meshes, and can screen out 7 kinds of finished products with different particle sizes in one operation. 1530 type, 1540 type, etc., its model is determined by the size of the linear motion vibrating sieve screen surface, that is, the length and width of the screen surface.

Such as 1030 type linear motion vibrating sieve, the size of the screen surface is 1.2 meters × 3 meters, the width of the screen surface is 1.2 meters, and the length of the screen surface is 3 meters.

Linear motion vibrating sieve key data

1. The shape and size of the sieve hole: the round sieve hole has a smaller particle size, and the square sieve hole has a larger material size. The size of the sieve hole is reasonably configured according to the material to be screened. 2-2.5 times.

2. Length and width of the screen surface: the wider the screen surface width, the thinner the material layer thickness will be, the greater the output, the longer the screen surface length, the longer the screening time, the more opportunities to pass through the screen, and the higher the screening efficiency. Generally, the ratio of width to length is 1:2~1:3.

3. Screen inclination angle: In general, linear motion vibrating sieves can be installed at a certain angle. If the inclination angle is too small, the material movement speed will be slow, and the productivity will be greatly reduced. If the inclination angle is too large, the discharge will be too fast, and the screening efficiency will be reduced. lower, so the inclination angle should be appropriate. Generally, we recommend that the gradient of linear motion vibrating sieve is 0-15°. If you want to screen special materials, you can increase the gradient appropriately, but it should not exceed 25°.

4. Motor excitation force: It must be higher than 30% of the total weight of the linear motion vibrating sieve.

The above is an introduction to the technical parameters of the conventional linear motion vibrating sieve. It can also be customized according to the actual use requirements, such as adding a distributor to the feeding port. The feeding port can be designed as a round or square according to the relevant configuration pipes. The shape, size and height can also be customized according to actual needs.