Huawei P10 Lite Display Replacement

Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.

After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

Flip the rear cover over to the right side of the phone.

Use a pair of tweezers to remove the sticker.

Remove the two Phillips #00 screws.

Remove the four 2.5 mm Phillips #00 screws.

Use tweezers to remove the mainboard shield.

Use the flat end of a spudger to disconnect the finger print sensor flex cable.

Remove the Phillips screw holding the battery connector plate in place.

Remove the battery connector plate.

Use the flat end of a spudger to disconnect the battery flex cable.

loosen the adhesive beneath the battery.

Insert a spudger between the battery and the mid frame to create a gap.

Be careful not to puncture or crease the battery.

Insert an opening pick or use the spuder in the gap to cut the adhesive beneath the battery.

Use a spudger to cut the rest of the adhesive and lever the battery out of the phone.

Remove the battery.

Remove the Philipps screw holding the display connection bracket in place.

Remove the display connection bracket.

Use the flat end of a spudger, to disconnect the display flex cable.

loosen the adhesive under the display.

Insert the tip of an opening pick between the display and the midframe.

Insert a second opening pick next to the other one.

Slide one of the opening picks round the phone, to cut the adhesive.

After you slid the opening pick completely around the phone, twist it at the top of the phone, to separate the display from the mid-frame.

Grab the phone at the upper part and separate the display from the frame while working the flex cable through the gap.