How to Start a printing service?
If you are a beginner at working with HTV and are facing trouble figuring it out, this article might be of some help to you. In this piece we will cover some basic tips, tricks and troubleshooting techniques to make working with HTV easy for you.
Troubleshooting Techniques
Plotter Cutting
The HTV always has two sides. A shiny side, and a dull side. Therefore, vinyl has three layers- sheet covering the adhesive, vinyl, and the carrier sheet. The shiny one is the carrier, and the dull one is the adhesive side. The dull side receives the cut when loaded into the cutter. Therefore, when loading the vinyl into the cutter, the shiny side goes down and the dull side goes up.
Test Cuts
We cannot emphasize enough on this one. Every vinyl has different thickness. This also differs from manufacturer to manufacturer. Hence, this setting differes accordingly too. The pressure of the cutter has to be just right to make sure that the adhesive side and the vinyl is cut properly. But it shouldn’t be so that it cuts through the carrier sheet as well.
To achieve this, test cuts on a small piece of vinyl have to be done.
领英推荐
Cut Lines are difficult to notice
When cutting on colours such as white or yellow, it can become harder to see the cut lines. In such cases try holding your HTV against the light to see and notice the cut lines. If the cut lines are still invisible, you can try adjusting the pressure of the cutter to cut a little deeper into the material.
Weeding seems very difficult
If the cuts have been made properly, you wouldn’t face much trouble while reading your design. A weeding tool is very helpful in this step. But if it is difficult still, you can try and adjust the cuts settings or double cut the design. In short, TEST CUT!
Transfer Not adhering properly
If the instructions to press the vinyl onto the respective garments are followed properly, the vinyl will adhere 100%. These instructions always come along with the heat vinyl. But sometimes, too much or too little press time can result into the vinyl not sticking properly. So, it’s necessary to follow the instructions properly.
If any interest, feel free to email me or message me for more details and quotation.