How to replace the load cell of Electronic scale?

How to replace the load cell of Electronic scale? The detail steps as follows:

1: Open the top cover of the load cell (damaged), lift the weighing platform with a jack, and remove the load cell ground wire.

2: Open the junction box and release the damaged sensor cable from the junction box. Pull out the cable at the sensor end. Note: When pulling the wire, attach a lead wire to pass through the scale body so that when a new load cell is replaced, the cable wire passes through the scale body and enters the junction box.

3: Refer to the second method above, and pass the sensor cable through the scale body into the junction box.

4: According to the wiring diagram, fix each core wire of the cable on the corresponding terminal of the junction box.

5: Loosen the jack, level the weighing platform, and cover the cover.

6: After replacing the weighing sensor, the truck scale must be reset and calibrated.

7: After the load cell is installed, the excess cables should be bundled and placed, not directly on the foundation ground.

8: In order to ensure the consistency and interchangeability of the sensor, the sensor cable shall not be cut off at will.

9: During installation and disassembly, no scratches or bumps on the load cell should occur, and the cables should be protected.

Want to know more products please visit our website: www.cranescaleloadcell.com , please feel freely contact with us: [email protected], We can sincerely hope we can Provide more valuable services!