How to install system into the rack of Dell PowerEdge R760?

How to install system into the rack of?Dell PowerEdge R760 ? There are two options: Drop-in and Stab-in, here isthe detail.

Drop-in design means that the system is installed vertically into the rails by inserting the standoffs on the sides of the system into the J-slots in the inner rail members with the rails in the fully extended position . The recommended method of installation is to first insert the rear standoffs on the system into the rear J-slots on the rails to free up a hand and then rotate the system down into the remaining J-slots while using the free hand to hold the rail against the side of the system .

Stab-in design means that the inner (chassis) rail members must first be attached to the sides of the system and then inserted into the outer (cabinet) members installed in the rack .

?

Installing system into the rack (option A: Drop-In)

?

1. Pull the inner rails out of the rack until they lock into place .

?

2. Locate the rear rail standoff on each side of the system and lower them into the rear J-slots on the slide assemblies .

3. Rotate the system downward until all the rail standoffs are seated in the J-slots .

4. Push the system inward until the lock levers click into place .

5. Pull the blue side release lock tabs forward or backward on both rails and slide the system into the rack until the system is in the rack .

Installing the system into the rack (option B: Stab-In)

?

1. Pull the intermediate rails out of the rack until they lock into place .

2. Release the inner rail lock by pulling forward on the white tabs and sliding the inner rail out of the intermediate rails .

Rail component label

3. Attach the inner rails to the sides of the system by aligning the J-slots on the rail with the standoffs on the system and sliding forward on the system until they lock into place .

4. With the intermediate rails extended, install the system into the extended rails .

5. Pull blue slide release lock tabs forward or backward on both rails, and slide the system into the rack .

Pre:PowerEdge R760 Power Supply Units Options

Next:Rails and cable management of Dell PowerEdge R760