How to fixing glass spigot on glass pool fence

Mark out the centre line of proposed glass fence with a chalk line. Determine clamp location based on a sheet size (recommemdation on page 1 & 2) Use base plate as a template to mark out the hole positions and drill holes to suit.

Note: Do not exceed 100mm gasp between glass panels, Optimum gap is 40mm to 60mm

Now the glass spigot can be fitted to the floor and plumbed via shims( not supplied) under the base plate. Be sure to tighten firmly as the smallest of movement at the base plate will result in noticeable movement at the bottom of the glass fence.

Tip: By setting the two outer spigots of your total span, a string line can be run in the “throat” of the spigots, giving correct height for all spigots in between.

Note: Do not exceed 100mm gap from the fixing surface to the bottom of the glass.

When all spigots are installed, slip domical cover the top of the spigot to hide fixings. It will be necessary to turn the adjustment screws on the spigot face all the wat in to allow cover to pass over.

Note: Same installation method applies to round base plate spigot.

The glass is then installed to the spigots. Place plastic packers between glass & spigot, at no stage should glass touch the metal.

How adjustability works:

1. Place glass in spigot

2. Fix/tension glass both sides with allen key.