Rig Electrical Engineer

Job: Rig Electrical Engineer

Location: Field (rigs)

Employment: Full time (Rotational 14 on / 14 off)

?

Job Overview: Responsible for maintaining all electrical systems.

?Duties & Responsibilities:

???Operate, maintain and repair main and emergency generators.

???Start up and bring online generators for parallel or split plant operation.

???Adjust load, power factor and frequency of generator.

??Monitor operating parameters of generators including but limited to temperature of generator, frequency, load sharing and protective devices.

??Repair or replace defective components as necessary.

??Operate, maintain and repair D.C. Power Conversion (SCR) including setting up systems for desired operating modes, clean, inspect breakers, motor starters, main contractors and electronic components.

??Troubleshoot and repair or replace SCR stacks, PC boards, contractors, breakers, control logic (solid state and relay) and related circuitry.

?? Maintain transformers including cleaning, inspection and testing of insulation of windings.

??Maintain and repair generator switch including troubleshooting and meter load, voltage, frequency, kvar and power factor.

??Troubleshoot and repair air and vacuum breakers, breakers and protective devices, voltage regulators and governor control on generator switch gear.

??Operate switchboard controls. Close and open distribution feeder circuit breakers and isolate circuits.

???Ensure that power is available and execute shut down in a kick/blowout.

??Secure ventilation system and/or power to affected area in a fire.

??Maintain and repair AC and DC motors.

??Maintain and repair across the on line or reduced voltage motor starters.

??Install, troubleshoot and repair multiple start-stop stations, switches (transducers, flow, lever, pressure, proximity, flow temperature etc.); timers, relays and solid-state switching devices.

??Repair BOP electrical control and indication system.

??Operate, maintain and repair refrigeration and air conditioning systems.

??Repair miscellaneous galley appliances and equipment.

??Repair hot water heaters.

??Maintain all fire detection and emergency equipment.

??Maintain and repair washing machines and dryers in the laundry.

??Maintain all lighting.

??Maintain and repair auxiliary electric brake.

??Maintain and repair all electrical equipment associated with pipe handling machines, top drive units, mud pumps, draw works and cranes as per preventative maintenance systems.

??Maintain, repair, connect, disconnect or isolate any other equipment installed either permanently or temporarily.

? Maintain and repair all fire/combustible gas/toxic gas detection and alarm equipment.

??Protect equipment from corrosion & mud.

? Read electrical schematics and electrical wiring diagrams, use technical manuals and references, find and interpret information and ensure that relevant information is available for equipment.

??Perform basic power calculations such as resistance, poser factor and voltage drop etc.

??Ensure oscilloscopes, multi-meters and test equipment is available and serviced.

??Perform tests such as insulation test, vibration tests, resistive load bank, dielectric absorption and D.C high potential tests etc.

??Know and understand all relevant rules for electrical equipment installed in hazardous zones and comply with same.

? Perform or verify electrical isolation. Perform or verify Lock out / Tag out.

??Maintain daily log and maintenance records.

??Prepare periodic report on work done and planned.

??Record and report performed maintenance per Maintenance Management System. (PMS).

??Report on operating procedures and equipment failures.

??Monitor spares and supplies; suggest re-order limit changes if necessary. Request needed parts or equipment as necessary.

??Coordinate with other departments and assist during troubleshooting or repair.

??Advise his supervisor of current and/or changing conditions.

??Supervise assigned subordinates and set priorities on work.

??Ensure that EDC Safety Management System Procedures and Practices are followed.

??Aware of his roles and responsibilities in emergency situations.

?

Minimum Qualifications:

·??Relevant Engineering degree (Electrical Engineer/Mechatronics).

·??5+ years relevant experience as a Senior Electrical Engineer.

·??Good English Level.

·??Good Communication Skills.

?

If you're interested, please apply to the below link:

?https://www.egyptian-drilling.com/career/senior-electrical-engineer/