Automatic Garage Door Safety

Automatic Garage Door Safety

Automatic garage doors are like magic.? We push the remote in our car, the door opens, we drive in, and we push the button beside the door to close the door behind us. What could go wrong?

But an automatic garage door can be deadly. Sadly, in the United States about 3 children are trapped and killed under automatic garage doors every year.

PHOTOELECTRIC SAFETY SENSOR (“ELECTRIC EYE”)

Garage door openers have two different safety mechanisms.? The photoelectric sensor (or “electric eye”) will detect if anything – or more importantly anyone – is in the path of the closing door.? The door will reverse to the fully open position if the sensor detects anything in the way.? To be effective, these sensors must be installed four to six inches high.? If the sensor is more than six inches high, a toddler crawling on the garage floor or an adult who has fallen could be trapped and crushed by the closing door.? To test this mechanism, make sure the sensor is four to six inches high, and as the garage door is closing, put your hand over one of the “eyes”.? The door should immediately reverse to the open position.

No alt text provided for this image
This sensor is too high (4-6 inches is right)


FORCE SETTING

The second safety mechanism is a force sensor.? If the garage door opener senses an obstruction while the door is closing, the door will reverse to the open position. A one and one-half inch obstruction at the bottom of the garage door should cause the door to reverse.? To test the safety mechanism, place a “2x4” piece of lumber under the garage door.? The door should reverse when it encounters the lumber.? If it doesn’t you can probably adjust the sensitivity of the force sensor via an adjusting knob, usually located on the back of the motor.? Adjust the sensitivity so that the door reverses when it hits the lumber.

No alt text provided for this image
The garage door should automatically reverse when it encounters a 2x4


ARE BOTH NEEDED?

Isn’t one of these safety mechanisms enough?? Not when it’s a matter of life and death!? If one of the safety mechanisms fail or is mis-adjusted, the other may prevent a serious injury or even save a life.

BALANCE

Even apart from the automatic operation of the opener, a garage door should be properly balanced.? With the “quick release” mechanism pulled, the garage door should be moderately easy to open manually.? It should remain stationary about halfway up.? It should not crash down quickly or fly up quickly.? A door that is not rightly balanced can be difficult to open manually in an emergency (e.g., during a power failure) and may also wear out the opener motor more quickly. ?If it crashes down quickly it could injure someone trying to open the door or standing nearby. Adjusting the balance for a garage door is a job for a professional – the springs holding up the garage door contain a huge amount of energy and can be deadly.

No alt text provided for this image
The garage door should remain stationary with the quick release handle pulled and the door half way up.


QUICK RELEASE

Speaking of opening the door during an emergency or a power outage, the garage door opener should have a “quick release” handle to disengage the opener from the door.? This is usually a red handle or knob attached with a red cord to the opener mechanism.? It should be easy for an adult to pull – e.g., no more than six feet four inches high (the average standing reach of a 4 foot 9 inch tall person), but difficult for a small child to pull – e.g., at least five feet high. Once pulled the door can be opened manually. Be careful to not pull the cord unless the door is fully closed. If the door is open but not properly balanced it might come crashing down once the handle is pulled. Operating the opener after pulling the handle will re-engage the opener to the door. In some models the quick release mechanism remains in the released position until the lever the cord is attached to is pushed back into the “engaged” position.

No alt text provided for this image
This quick release handle is at the right height (min 5 feet and max 6 feet 4 inches)


HEIGHT OF OPENER BUTTON

While we want the garage door to be easy to operate, we don’t want a small child to be able to operate it unsupervised. For that reason, the opener button should be at least five feet high.

No alt text provided for this image
This opener button is too low - 5 foot minimum to keep out of reach of a small child


OVERVIEW

When I do a home inspection, I like to report the following:

  • The garage door operator opened and closed the door when the button was pushed.? The operator button is at least five feet high to keep out of reach of a child.
  • The garage door reversed when it detected a broken light beam between the safety sensors, and the sensors were four to six inches high.
  • The garage door reversed when it encountered a 1-1/2 inch obstruction on the floor.
  • The “quick release” disengaged and re-engaged the opener, and the “quick release” can be engaged by pulling a handle at least 5 feet high and no more than 6 feet 4 inches high.
  • The garage door remains open halfway up with the “quick release” pulled.
  • The door itself is in good condition.? All the rollers are in the tracks, it opens and closes smoothly, no panels are loose, and no screws or bolts are missing.

REFERENCES

U.S. Consumer Product Safety Commission - safety alert regarding garage door openers

Easley Services Blog - Automatic Garage Door Safety

要查看或添加评论,请登录

Dan Easley的更多文章

  • Deck Guard Safety

    Deck Guard Safety

    When I was a 7 year old boy I had no fear of heights. I loved to climb on top of things: curbs, dirt piles, and yes…

  • What is a Cross-Connection?

    What is a Cross-Connection?

    A cross-connection is a place where dirty water can get into the clean drinking water (“potable” water). When you turn…

    1 条评论
  • Why Is Water Coming Into My Basement?

    Why Is Water Coming Into My Basement?

    When I first bought my home in Fitchburg, I noticed that the corner of the basement collected a puddle of water after…

  • What is hiding in my electrical panel?

    What is hiding in my electrical panel?

    I first noticed that there was an open knock-out hole in the electrical panel. I removed the cover from the panel and…

  • Why is a GFCI outlet so important?

    Why is a GFCI outlet so important?

    When I was growing up, GFCI outlets didn’t exist. Why are they now required in kitchens, bathrooms, and other damp…

  • Why shouldn't my bathroom fan exhaust into the attic?

    Why shouldn't my bathroom fan exhaust into the attic?

    After I became a home inspector, I inspected my own home. Even though I’m a handy-man, I noticed several things that…

  • Why is water pouring out of my ceiling?

    Why is water pouring out of my ceiling?

    One sunny winter afternoon I came home to find water pouring out of my ceiling into my family room. “What is…

    1 条评论
  • Is adding more attic insulation always good?

    Is adding more attic insulation always good?

    You may think like I used to think – here in Wisconsin, adding more insulation to my attic is a no-brainer. The more…

  • I just started a Home Inspection business in Madison

    I just started a Home Inspection business in Madison

    I just started a home inspection business in Madison Wisconsin after having "retired" earlier this year. I love the…

    4 条评论
  • Two Days in a new position - Wow, Medicaid is complex!

    Two Days in a new position - Wow, Medicaid is complex!

    Two days into my new position with the State of Wisconsin Department of Health Services, Division of Medicaid Services…

    1 条评论

社区洞察

其他会员也浏览了