air blower for sewage treatment

1. The blades and covers of the sewage treatment air blower are made of hard ADC12 material in the world, which is equivalent to the steel ring of Mercedes-Benz wheels.?

Second, the bearing of the sewage treatment air blower adopts imported bearings with high speed and high temperature resistance, which is 2800 rpm in the case of 50Hz and 3450 rpm in the case of 60Hz, free of lubrication and maintenance for 20000 hours, which is equivalent to continuous operation for 2 years.?

Third, the sewage treatment air blower in and out of the tuyere are equipped with built-in muffler pipe, so as to achieve low noise.?

4. The models below 1.1KW for sewage treatment fan can be used under full pressure.?

Fifth, the pressure of the sewage treatment air blower is stable. Through the application of water treatment and electroplating treatment, it is proved that the mixing is uniform and the water wave tumbling height *.?

Sixth, the flow rate of sewage treatment air blower is larger than that of similar products under the same power and pressure.?

Seventh, the air cover of the sewage treatment fan adopts a sheet heat dissipation design, which is equivalent to the heat dissipation device of the motorcycle engine, which greatly reduces the temperature of the fan during operation.?

Eighth, the sewage treatment air blower adopts the bearing front design principle, and the two bearings are placed at the front end of the fan blade and the back end of the motor to achieve the dynamic balance configuration and is conducive to heat dissipation.?

(the reason is that the front end of the blade has a heat sink to dissipate heat, while the back end bearing works under the cooling fan of the sewage treatment high pressure air blower, thus keeping the bearing working at low temperature.).?

Ninth, the sewage treatment air blower adopts a special shockproof pedestal design, thus greatly reducing the vibration produced in the operation of the air blower!